Modify

Opened 7 years ago

Last modified 4 years ago

#9673 new defect

compex np27g (adm5120) not run WiFi

Reported by: skydark@… Owned by: developers
Priority: high Milestone: Barrier Breaker 14.07
Component: base system Version:
Keywords: Cc:

Description

Atheros ar5005g (miniPCI) not run all openWRT builds...

router: Compex np27g 2SDRAM 16Bits Rev A1
radio: Atheros MB51 rev A1

root@OpenWrt:/# opkg install kmod-madwifi
Installing kmod-madwifi (2.6.32.33+r3314-5) to root...
Downloading http://downloads.openwrt.org/snapshots/trunk/adm5120/packages/kmod-madwifi_2.6.32.33+r3314-5_adm5120_mipsel.ipk.
Installing wireless-tools (29-4) to root...
Downloading http://downloads.openwrt.org/snapshots/trunk/adm5120/packages/wireless-tools_29-4_adm5120_mipsel.ipk.
Configuring wireless-tools.
Configuring kmod-madwifi.
ath_hal: module license 'Proprietary' taints kernel.
Disabling lock debugging due to kernel taint
ath_hal: 2009-05-08 (AR5210, AR5211, AR5212, AR5416, RF5111, RF5112, RF2413, RF5413, RF2133, RF2425, REGOPS_FUNC, XR)
ath_pci: trunk
wlan: trunk
wlan: mac acl policy registered
ath_rate_minstrel: Minstrel automatic rate control algorithm 1.2 (trunk)
ath_rate_minstrel: look around rate set to 10%
ath_rate_minstrel: EWMA rolloff level set to 75%
ath_rate_minstrel: max segment size in the mrr set to 6000 us
PCI: Enabling device 0000:00:02.0 (0000 -> 0002)
wifi0: request_irq failed
root@OpenWrt:/#


dmesg:

Linux version 2.6.32.33 (buildslave@dd.das-iro.de) (gcc version 4.5.4 20110505 (prerelease) (Linaro GCC 4.5-2011.05-0) ) #1 Thu Jun 30 12:53:34 CEST 2011
bootconsole [early0] enabled
CPU revision is: 0001800b (MIPS 4Kc)
SoC      : ADM5120 rev 8, running at 175.000 MHz
Bootdev  : NOR flash
Prom     : MyLoader
Determined physical RAM map:
 memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00001000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00001000
On node 0 totalpages: 4096
free_area_init_node: node 0, pgdat 8025c4c0, node_mem_map 80298000
  Normal zone: 32 pages used for memmap
  Normal zone: 0 pages reserved
  Normal zone: 4064 pages, LIFO batch:0
Built 1 zonelists in Zone order, mobility grouping off.  Total pages: 4064
Kernel command line: console=ttyS0,115200 rootfstype=squashfs,yaffs2,jffs2
PID hash table entries: 64 (order: -4, 256 bytes)
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Primary instruction cache 8kB, VIPT, 2-way, linesize 16 bytes.
Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes
Memory: 13568k/16384k available (1990k kernel code, 2816k reserved, 424k data, 136k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:24
Calibrating delay loop... 173.05 BogoMIPS (lpj=346112)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is Compex NetPassage 27G
registering PCI controller with io_map_base unset
bio: create slab <bio-0> at 0
pci 0000:00:00.0: reg 10 32bit mmio: [0xf0000000-0xffffffff]
pci 0000:00:02.0: reg 10 32bit mmio: [0x000000-0x00ffff]
PCI: pci_irq_map is not initialized
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
yaffs Jun 30 2011 12:50:11 Installing.
msgmni has been set to 26
io scheduler noop registered
io scheduler deadline registered (default)
Serial: AMBA driver
apb:uart0: ttyS0 at MMIO 0x12600000 (irq = 9) is a AMBA
console [ttyS0] enabled, bootconsole disabled
apb:uart1: ttyS1 at MMIO 0x12800000 (irq = 10) is a AMBA
adm5120-flash.0: probing at 0x1FC00000, size:4096KiB, width:16 bits
adm5120-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
 CFI mfr 0x000000c2
 CFI id  0x000022a8
 Amd/Fujitsu Extended Query Table at 0x0040
  Amd/Fujitsu Extended Query version 1.1.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
adm5120-flash.0: found at 0x1FC00000, size:4096KiB, width:16 bits
adm5120-flash.0: parsing "cmdlinepart" partitions
adm5120-flash.0: parsing "MyLoader" partitions
adm5120-flash.0: searching for MyLoader partition table at offset 0x10000
4 MyLoader partitions found on MTD device adm5120-flash.0
adm5120-flash.0: adding "MyLoader" partitions
Creating 4 MTD partitions on "adm5120-flash.0":
0x000000000000-0x000000010000 : "myloader"
0x000000010000-0x000000020000 : "partition_table"
0x000000020000-0x000000030000 : "partition0"
0x000000030000-0x000000400000 : "partition1"
ADM5120 built-in ethernet switch driver version 0.1.1
adm5120_wdt: Watchdog Timer version 0.1
TCP westwood registered
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
trxsplit: searching TRX header in 'myloader'
trxsplit: searching TRX header in 'partition_table'
trxsplit: searching TRX header in 'partition0'
trxsplit: searching TRX header in 'partition1'
trxsplit: TRX header found at 0x0
trxsplit: creating TRX partitions in 'partition1' (31,3)
Creating 2 MTD partitions on "partition1":
0x00000000001c-0x0000000e0000 : "kernel"
mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only
0x0000000e0000-0x0000003d0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
split_squashfs: no squashfs found in "partition1"
yaffs: dev is 32505861 name is "mtdblock5"
yaffs: passed flags ""
yaffs: Attempting MTD mount on 31.5, "mtdblock5"
yaffs: MTD device is not NAND it's type 3
jffs2_scan_eraseblock(): End of filesystem marker found at 0x170000
jffs2_build_filesystem(): unlocking the mtd device... done.
jffs2_build_filesystem(): erasing all blocks after the end marker... done.
VFS: Mounted root (jffs2 filesystem) readonly on device 31:5.
Freeing unused kernel memory: 136k freed
Please be patient, while OpenWrt loads ...
Button Hotplug driver version 0.4.1
device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering forwarding state
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
nf_conntrack version 0.5.0 (214 buckets, 856 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
br-lan: port 1(eth0) entering disabled state
br-lan: port 1(eth0) entering forwarding state
adm5120_wdt: enabling watchdog timer
ath_hal: module license 'Proprietary' taints kernel.
Disabling lock debugging due to kernel taint
ath_hal: 2009-05-08 (AR5210, AR5211, AR5212, AR5416, RF5111, RF5112, RF2413, RF5413, RF2133, RF2425, REGOPS_FUNC, XR)
ath_pci: trunk
wlan: trunk
wlan: mac acl policy registered
ath_rate_minstrel: Minstrel automatic rate control algorithm 1.2 (trunk)
ath_rate_minstrel: look around rate set to 10%
ath_rate_minstrel: EWMA rolloff level set to 75%
ath_rate_minstrel: max segment size in the mrr set to 6000 us
PCI: Enabling device 0000:00:02.0 (0000 -> 0002)
wifi0: request_irq failed

Why PCI: pci_irq_map is not initialized ?

Attachments (0)

Change History (1)

comment:1 Changed 4 years ago by jow

  • Milestone changed from Attitude Adjustment 12.09 to Barrier Breaker 14.07

Milestone Attitude Adjustment 12.09 deleted

Add Comment

Modify Ticket

Action
as new .
Author


E-mail address and user name can be saved in the Preferences.

 
Note: See TracTickets for help on using tickets.