Patch to allow OpenWRT to run on Tranzeo Kolsch and Taihushui platforms

[dpaulic@…]

Enhancement: The patches in the attached tar.bz2 file have been written to allow OpenWRT to run on Tranzeo's Kolsch and Taihushui platforms. A Quick Rundown of each platform follows:

Kolsch:
Processor: AMCC PowerPC 405EP Rev. B at 330 MHz
LEDS: 4 red, 5 amber high intensity SMT (One red hardwired to power, balance on GPIO)
SDRAM: 64 MB
Boot Flash: 2 MB
Flash: 64 MB
Radio Slot: 1 x MiniPCI
Ethernet: 1 x 10/100 Base T
Serial Header: On board (Can post pinout on wiki)
JTAG: On PCB layout not populated by default. (Can post pinout on wiki)

Taihushui:
Processor: AMCC PowerPC 405EP Rev. B at 330 MHz
LEDS: 4 red, 5 amber high intensity SMT (One red hardwired to power, balance on GPIO)
SDRAM: 128 MB
Boot Flash: 2 MB
Application Flash: 64 MB
Radio Slot: 2 x MiniPCI
Ethernet: 2 x 10/100 Base T
Serial Header: On board (Can post pinout on wiki)
JTAG Header: On PCB layout, not populated by default. (Can post pinout on wiki)

Instructions on how to install the firmware on the boards will be created on the OpenWRT wiki.

[dpaulic@…]

Please Note: Tranzeo does not provide ANY official support for these patches. Therefore, install at your own risk.

[kaloz]

Great, thanks! I'll review it soon..

[tripolar]

please send a patch created from current trunk to the ml