Modify

Opened 22 months ago

Last modified 19 months ago

#22178 new defect

USB3 is not working on Belkin F9K1115 v2 (AC 1750 DB)

Reported by: ferrets@… Owned by: developers
Priority: high Milestone:
Component: kernel Version: Chaos Calmer 15.05
Keywords: USB3 F9K1115 Belkin Cc:

Description

using the newest version 15.05.1,a usb 2.0 flash disk is plugged in and working fine.

after I plug in the usb3.0 disk, the disk can be recognized by the system and fdisk.

but when I tried to format it into ext4, it caused a crash and the usb3.0 port is not working anymore until the router is rebooted.

here is some log

dmesg for plug in and recognize
[903770.750000] usb 4-1: new SuperSpeed USB device number 2 using xhci_hcd
[903770.770000] usb-storage 4-1:1.0: USB Mass Storage device detected
[903770.780000] scsi host1: usb-storage 4-1:1.0
[903771.790000] scsi 1:0:0:0: Direct-Access     SanDisk  Ultra Fit        1.00 PQ: 0 ANSI: 6
[903771.800000] sd 1:0:0:0: [sdb] 60062500 512-byte logical blocks: (30.7 GB/28.6 GiB)
[903771.810000] sd 1:0:0:0: [sdb] Write Protect is off
[903771.820000] sd 1:0:0:0: [sdb] Mode Sense: 43 00 00 00
[903771.820000] sd 1:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[903771.840000]  sdb: sdb1
[903771.850000] sd 1:0:0:0: [sdb] Attached SCSI removable disk
fdisk is able to recognize partition information
Disk /dev/sdb: 28.7 GiB, 30752000000 bytes, 60062500 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disklabel type: dos
Disk identifier: 0x00000000

Device     Boot Start      End  Sectors  Size Id Type
/dev/sdb1          32 60062499 60062468 28.7G  c W95 FAT32 (LBA)
crash log at trying to format the disk
[904442.060000] xhci_hcd 0000:01:00.0: xHCI host not responding to stop endpoint command.
[904442.060000] xhci_hcd 0000:01:00.0: Assuming host is dying, halting host.
[904442.070000] xhci_hcd 0000:01:00.0: HC died; cleaning up
[904442.080000] usb 4-1: USB disconnect, device number 2
[904442.100000] sd 1:0:0:0: [sdb]
[904442.100000] Result: hostbyte=0x01 driverbyte=0x00
[904442.100000] sd 1:0:0:0: [sdb] CDB:
[904442.110000] cdb[0]=0x2a: 2a 00 00 00 00 20 00 00 08 00
[904442.110000] blk_update_request: I/O error, dev sdb, sector 32
[904442.120000] Buffer I/O error on dev sdb1, logical block 0, lost async page write
[904442.130000] Buffer I/O error on dev sdb1, logical block 1, lost async page write
[904442.150000] sd 1:0:0:0: [sdb]
[904442.150000] Result: hostbyte=0x01 driverbyte=0x00
[904442.160000] sd 1:0:0:0: [sdb] CDB:
[904442.160000] cdb[0]=0x2a: 2a 00 00 00 00 38 00 00 f0 00
[904442.170000] blk_update_request: I/O error, dev sdb, sector 56
[904442.170000] Buffer I/O error on dev sdb1, logical block 6, lost async page write
[904442.180000] Buffer I/O error on dev sdb1, logical block 7, lost async page write
[904442.190000] Buffer I/O error on dev sdb1, logical block 8, lost async page write
[904442.200000] Buffer I/O error on dev sdb1, logical block 9, lost async page write
[904442.200000] Buffer I/O error on dev sdb1, logical block 10, lost async page write
[904442.210000] Buffer I/O error on dev sdb1, logical block 11, lost async page write
[904442.220000] Buffer I/O error on dev sdb1, logical block 12, lost async page write
[904442.230000] Buffer I/O error on dev sdb1, logical block 13, lost async page write
[904442.360000] ------------[ cut here ]------------
[904442.370000] WARNING: CPU: 0 PID: 26080 at fs/fs-writeback.c:1215 __mark_inode_dirty+0x114/0x1ac()
[904442.380000] bdi-block not registered
[904442.380000] Modules linked in: pppoe ppp_async iptable_nat ath9k ums_usbat ums_sddr55 ums_sddr09 ums_karma ums_jumpshot ums_isd200 ums_freecom ums_datafab ums_cypress ums_alauda pppox ppp_generic nf_nat_ipv4 nf_conntrack_ipv6 nf_conntrack_ipv4 ipt_REJECT ipt_MASQUERADE ath9k_common xt_time xt_tcpudp xt_state xt_nat xt_multiport xt_mark xt_mac xt_limit xt_id xt_conntrack xt_comment xt_TCPMSS xt_REDIRECT xt_LOG xt_CT usb_storage slhc nf_reject_ipv4 nf_nat_masquerade_ipv4 nf_nat_ftp nf_nat nf_log_ipv4 nf_defrag_ipv6 nf_defrag_ipv4 nf_conntrack_rtcache nf_conntrack_ftp nf_conntrack iptable_raw iptable_mangle iptable_filter ip_tables crc_ccitt ath9k_hw ath10k_pci ath10k_core ath mac80211 cfg80211 compat ledtrig_usbdev ip6t_REJECT nf_reject_ipv6 nf_log_ipv6 nf_log_common ip6table_raw ip6table_mangle ip6table_filter ip6_tables x_tables sd_mod scsi_mod tun ext4 jbd2 mbcache crc16 ipv6 arc4 crypto_blkcipher crypto_hash xhci_plat_hcd xhci_pci xhci_hcd ehci_platform ehci_hcd gpio_button_hotplug usbcore nls_base usb_common
[904442.470000] CPU: 0 PID: 26080 Comm: mkfs.ext4 Not tainted 3.18.23 #1
[904442.480000] Stack : 00000000 00000000 00000000 00000000 803d4292 00000038 00000000 8011f154
[904442.480000]           00000001 ffffffff 8031f208 80376ba3 000065e0 803d34d0 878f4248 ffffffff
[904442.480000]           00000000 00001000 00000001 800a364c 00000003 8008043c 000004bf ffffffff
[904442.480000]           80322800 83587c04 00000000 00000000 00000000 00000000 00000000 00000000
[904442.480000]           00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
[904442.480000]           ...
[904442.520000] Call Trace:
[904442.520000] [<80071060>] show_stack+0x50/0x84
[904442.520000] [<80080544>] warn_slowpath_common+0x84/0xb4
[904442.530000] [<800805a0>] warn_slowpath_fmt+0x2c/0x38
[904442.530000] [<8011f154>] __mark_inode_dirty+0x114/0x1ac
[904442.540000] [<8012684c>] __block_commit_write.isra.28+0xb0/0x120
[904442.550000] [<8012692c>] block_write_end+0x70/0x8c
[904442.550000] [<8012a52c>] blkdev_write_end+0x34/0x60
[904442.560000] [<800c82fc>] generic_perform_write+0x124/0x1f4
[904442.560000] [<800ca058>] __generic_file_write_iter+0x360/0x3f4
[904442.570000] [<8012a6a4>] blkdev_write_iter+0x34/0xec
[904442.570000] [<800fb82c>] new_sync_write+0x88/0xc0
[904442.580000] [<800fc15c>] vfs_write+0xb8/0x1bc
[904442.580000] [<800fc8cc>] SyS_pwrite64+0x6c/0xb4
[904442.590000] [<80062b5c>] handle_sys+0x11c/0x140
[904442.590000]
[904442.590000] ---[ end trace 1ba70ff86f69ef12 ]---
installed kmod-usb
root@Belkin:~# opkg list-installed | grep kmod-usb
kmod-usb-core - 3.18.23-1
kmod-usb-storage - 3.18.23-1
kmod-usb-storage-extras - 3.18.23-1
kmod-usb2 - 3.18.23-1
kmod-usb3 - 3.18.23-1

Attachments (1)

dmesg.txt (24.7 KB) - added by ferrets@… 22 months ago.
full dmesg log

Download all attachments as: .zip

Change History (3)

Changed 22 months ago by ferrets@…

full dmesg log

comment:1 Changed 19 months ago by anonymous

I also am not able to use a usb3 storage on this device. It detects the hub and external device correctly, but when using it gives the same as above and drops the usb3 drivers. I've tried a sdd usb 3.0 thumb drive and external storage device.

comment:2 Changed 19 months ago by anonymous

Linking another ticket of similar issue : /ticket/20142.html

Add Comment

Modify Ticket

Action
as new .
Author


E-mail address and user name can be saved in the Preferences.

 
Note: See TracTickets for help on using tickets.