Opened 5 years ago
Last modified 18 months ago
#13636 assigned defect
Cannot mount rootfs
Reported by: | anonymous | Owned by: | florian |
---|---|---|---|
Priority: | highest | Milestone: | Barrier Breaker 14.07 |
Component: | packages | Version: | Trunk |
Keywords: | Cc: |
Description
Image: generic, titan(all)
Hardware: RTP300
outcome:
Booting...
[ 0.000000] Linux version 3.3.8 (blogic@Debian-60-squeeze-64-minimal) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Sat Mar 23 14:45:52 UTC 2013
[ 0.000000] gpiochip_add: registered GPIOs 0 to 50 on device: titan-gpio
[ 0.000000] titan-gpio: registered 51 GPIOs
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 00018448 (MIPS 4KEc)
[ 0.000000] TI AR7 (TNETV1050), ID: 0x0007, Revision: 0x02
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 01000000 @ 14000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone PFN ranges:
[ 0.000000] Normal 0x00014000 -> 0x00015000
[ 0.000000] Movable zone start PFN for each node
[ 0.000000] Early memory PFN ranges
[ 0.000000] 0: 0x00014000 -> 0x00015000
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064
[ 0.000000] Kernel command line: console=ttyS0,115200n8 rootfstype=squashfs,jffs2
[ 0.000000] PID hash table entries: 64 (order: -4, 256 bytes)
[ 0.000000] Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.000000] Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes.
[ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 16 bytes
[ 0.000000] Memory: 11952k/16384k available (2467k kernel code, 4432k reserved, 365k data, 172k init, 0k highmem)
[ 0.000000] NR_IRQS:256
[ 0.000000] Calibrating delay loop... 148.88 BogoMIPS (lpj=744448)
[ 0.070000] pid_max: default: 32768 minimum: 301
[ 0.070000] Mount-cache hash table entries: 512
[ 0.090000] NET: Registered protocol family 16
[ 0.140000] bio: create slab <bio-0> at 0
[ 0.160000] Switching to clocksource MIPS
[ 0.170000] NET: Registered protocol family 2
[ 0.180000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.190000] TCP established hash table entries: 512 (order: 0, 4096 bytes)
[ 0.200000] TCP bind hash table entries: 512 (order: -1, 2048 bytes)
[ 0.200000] TCP: Hash tables configured (established 512 bind 512)
[ 0.210000] TCP reno registered
[ 0.210000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.220000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.230000] NET: Registered protocol family 1
[ 0.300000] unable to register fixed phy for cpmac-high: 0
[ 0.320000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.320000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.340000] msgmni has been set to 23
[ 0.340000] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 254)
[ 0.350000] io scheduler noop registered
[ 0.350000] io scheduler deadline registered (default)
[ 0.360000] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled
[ 0.370000] serial8250: ttyS0 at MMIO 0x8610e00 (irq = 15) is a TI-AR7
[ 0.380000] console [ttyS0] enabled, bootconsole disabled
[ 0.380000] console [ttyS0] enabled, bootconsole disabled
[ 0.390000] serial8250: ttyS1 at MMIO 0x8610f00 (irq = 16) is a TI-AR7
[ 0.430000] physmap platform flash device: 02000000 at 10000000
[ 0.440000] physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x000001 Chip ID 0x001000
[ 0.450000] Amd/Fujitsu Extended Query Table at 0x0040
[ 0.460000] Amd/Fujitsu Extended Query version 1.3.
[ 0.460000] number of CFI chips: 1
[ 0.470000] titan: BOOTCFG variable not found.
[ 0.490000] Fixed MDIO Bus: probed
[ 6.670000] INTERNAL PHY!!!
[ 6.730000] cpmac-mii: probed
[ 6.810000] cpmac: device eth0 (regs: 08640800, irq: 41, phy: cpmac-1:1f, mac: 00:1a:70:80:12:4f)
[ 6.890000] cpmac: device eth1 (regs: 08640000, irq: 27, phy: cpmac-1:1e, mac: 00:1a:70:80:12:4e)
[ 6.910000] vlynq0: regs 0x08611c00, irq 33, mem 0x0c000000
[ 7.820000] vlynq1: regs 0x08611300, irq 34, mem 0x40000000
[ 8.730000] TCP cubic registered
[ 8.730000] NET: Registered protocol family 17
[ 8.740000] Bridge firewalling registered
[ 8.740000] 8021q: 802.1Q VLAN Support v1.8
[ 8.750000] VFS: Cannot open root device "(null)" or unknown-block(0,0)
[ 8.760000] Please append a correct "root=" boot option; here are the available partitions:
[ 8.770000] Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0)
[ 8.780000] Rebooting in 3 seconds..
tried every possible setting (setenv and boot root=) think there is an error in MTD driver for 1050. used to work some time ago in image where eth1 didnt work
or I just do not get what settings are right
Attachments (0)
Change History (8)
comment:1 Changed 5 years ago by anonymous
comment:2 Changed 5 years ago by anonymous
so i will answer myself images to download for titan have wrong kernel compiled in - had to compile my own and it boots now, but still can't make adm6996L switch to work
comment:3 Changed 5 years ago by blogic
- Owner changed from developers to florian
- Status changed from new to assigned
comment:4 Changed 4 years ago by jow
- Milestone changed from Attitude Adjustment 12.09 to Barrier Breaker 14.07
Milestone Attitude Adjustment 12.09 deleted
comment:5 Changed 3 years ago by florian
The titan partition parser did not parse any partitions, could you find a fix for this?
comment:6 Changed 3 years ago by anonymous
same here, "VFS: Cannot open root device" at boot, then kernel panic. any hopes to get it working?
comment:7 Changed 3 years ago by anonymous
(still not working in barrier breaker and/or current trunk)
comment:8 Changed 18 months ago by anonymous
Usb unmount
oh i forgot, bootloader is PSPBoot 1.3.3.11