Modify

Opened 6 years ago

Closed 6 years ago

Last modified 4 years ago

#10029 closed defect (duplicate)

issue with svn revision 28136

Reported by: anonymous Owned by: developers
Priority: normal Milestone: Barrier Breaker 14.07
Component: packages Version: Trunk
Keywords: Cc:

Description

There is a problem with the latest build of the openwrt source codes.

  1. I don't get the console via the serial port.
  2. I can't connect to the system after it is not properly power off.

{{{RedBoot(tm) bootstrap and debug environment [ROMRAM]
Ubiquiti Networks certified release, version 0.9.00318.0905071532 - built 15:33:10, May 7 2009

Copyright (C) 2000, 2001, 2002, 2003, 2004 Red Hat, Inc.

Board: Ubiquiti Ubiquiti AR71xx-based board (Ubiquiti RouterStation detected)

Arch: ar7100

RAM: 0x80000000-0x84000000, [0x8003bf00-0x83fe1000] available

Flash: 0xbf000000-0xc0000000, in 256 blocks of 0x00010000 bytes each

Executing boot script in 1.000 seconds - enter C to abort

RedBoot> fis load -d -e kernel
Trying LZMA decompression...
Image loaded from 0x80060000-0x802e0b80
Image is not ELF, skipping ELF parsing...
RedBoot> exec
Now booting linux kernel:

Base address 0x80050000 Entry 0x80060000
memsize=0x04000000
modetty0=0,n,8,1,hw
board=Ubiquiti AR71xx-based board
ethaddr=00.15.6d.c1.1f.72

Linux version 2.6.39.4 (phu@MeshServer4) (gcc version 4.5.4 20110808 (prerelease) (Linaro GCC 4.5-2011.08) ) #11 Wed Aug 31 16:28:54 E1
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
SoC: Atheros AR7161 rev 2
Clocks: CPU:680.000MHz, DDR:340.000MHz, AHB:170.000MHz, Ref:40.000MHz
Determined physical RAM map:

memory: 04000000 @ 00000000 (usable)

Initrd not found or empty - disabling initrd
Zone PFN ranges:

Normal 0x00000000 -> 0x00004000

Movable zone start PFN for each node
early_node_map[1] active PFN ranges

0: 0x00000000 -> 0x00004000

Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: board=UBNT-RS console=ttyS0,115200 ethaddr=00.15.6d.c1.1f.72 rootfstype=squashfs,jffs2 noinitrd
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00077f32
Readback ErrCtl register=00077f32
Memory: 61876k/65536k available (1998k kernel code, 3660k reserved, 387k data, 176k init, 0k highmem)
SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:80
Calibrating delay loop... 452.19 BogoMIPS (lpj=2260992)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is Ubiquiti RouterStation
registering PCI controller with io_map_base unset
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
msgmni has been set to 120
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: found mx25l12805d, expected m25p80
m25p80 spi0.0: mx25l12805d (16384 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0xfe0000
Searching for RedBoot partition table in spi0.0 at offset 0xff0000
5 RedBoot partitions found on MTD device spi0.0
Creating 5 MTD partitions on "spi0.0":
0x000000000000-0x000000030000 : "RedBoot"
0x000000030000-0x000000110000 : "kernel"
0x000000110000-0x000000ff0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
split_squashfs: no squashfs found in "spi0.0"
0x000000ff0000-0x000000fff000 : "FIS directory"
0x000000fff000-0x000001000000 : "RedBoot config"
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
eth1: Atheros AG71xx at 0xba000000, irq 5
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@…>
All bugs added by David S. Miller <davem@…>
JFFS2 notice: (1) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0.
VFS: Mounted root (jffs2 filesystem) readonly on device 31:2.
Freeing unused kernel memory: 176k freed
input: gpio-keys-polled as /devices/platform/gpio-keys-polled/input/input0
Button Hotplug driver version 0.4.1

  • preinit -

Press the [f] key and hit [enter] to enter failsafe mode
eth0: link up (100Mbps/Full duplex)

  • regular preinit -
  • init -

Please press Enter to activate this console. eth1: link up (100Mbps/Full duplex)
Compat-wireless backport release: compat-wireless-2011-08-25
Backport based on wireless-testing.git master-2011-08-26
cfg80211: Calling CRDA to update world regulatory domain
SCSI subsystem initialized
cfg80211: World regulatory domain updated:
cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
PPP generic driver version 2.4.2
NET: Registered protocol family 24
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.


WARNING: at net/sched/sch_generic.c:256 0x801e9170()
NETDEV WATCHDOG: eth0 (ag71xx): transmit queue 0 timed out
Modules linked in: usb_storage sd_mod pppoe pppox nfs ppp_async ppp_generic slhc lockd sunrpc autofs4 ath9k ath9k_common ath9k_hw ath5e
Call Trace:[<801886d0>] 0x801886d0
[<80250994>] 0x80250994
[<80250994>] 0x80250994
[<80074e70>] 0x80074e70
[<801e9170>] 0x801e9170
[<80074f24>] 0x80074f24
[<801d85b8>] 0x801d85b8
[<801e9170>] 0x801e9170
[<800871f0>] 0x800871f0
[<801e9004>] 0x801e9004
[<8007f098>] 0x8007f098
[<8007a624>] 0x8007a624
[<802d0000>] 0x802d0000
[<802d0000>] 0x802d0000
[<8007a82c>] 0x8007a82c
[<800642d0>] 0x800642d0
[<800610e0>] 0x800610e0
[<8006258c>] 0x8006258c
[<80062760>] 0x80062760
[<802d0000>] 0x802d0000
[<8006151c>] 0x8006151c
[<80063fcc>] 0x80063fcc
[<80062780>] 0x80062780
[<802b58d0>] 0x802b58d0
[<802b521c>] 0x802b521c

---[ end trace c946e3d0ef8660b3 ]---
}}}

Attachments (0)

Change History (2)

comment:1 Changed 6 years ago by nbd

  • Resolution set to duplicate
  • Status changed from new to closed

see #11217

comment:2 Changed 4 years ago by jow

  • Milestone changed from Attitude Adjustment 12.09 to Barrier Breaker 14.07

Milestone Attitude Adjustment 12.09 deleted

Add Comment

Modify Ticket

Action
as closed .
The resolution will be deleted. Next status will be 'reopened'.
Author


E-mail address and user name can be saved in the Preferences.

 
Note: See TracTickets for help on using tickets.