Changeset 8932


Ignore:
Timestamp:
2007-09-21T21:00:45+02:00 (10 years ago)
Author:
juhosg
Message:

[adm5120] rename NAND driver

Location:
trunk/target/linux/adm5120
Files:
2 edited
1 moved

Legend:

Unmodified
Added
Removed
  • trunk/target/linux/adm5120/patches-2.6.22/004-adm5120_nand.patch

    r8196 r8932  
    33--- linux-2.6.22.1.orig/drivers/mtd/nand/Kconfig 
    44+++ linux-2.6.22.1/drivers/mtd/nand/Kconfig 
    5 @@ -81,6 +81,12 @@ config MTD_NAND_TS7250 
     5@@ -81,6 +81,16 @@ config MTD_NAND_TS7250 
    66        help 
    77          Support for NAND flash on Technologic Systems TS-7250 platform. 
    88  
    9 +config MTD_NAND_RB100 
    10 +       tristate "NAND Flash device on RB100 board" 
    11 +       depends on MTD_NAND 
     9+config MTD_NAND_ADM5120 
     10+       tristate "ADM5120 NAND support" 
     11+       depends on MTD_NAND && MIPS_ADM5120 
    1212+       help 
    13 +         Support for NAND flash on RB100 platform. 
     13+         This enables the driver for the ADM5120 SoC built-in 
     14+         NAND flash interface. 
     15+ 
     16+         No board specific support is done by this driver, each board 
     17+         must advertise a platform_device for the driver to attach. 
    1418+ 
    1519 config MTD_NAND_IDS 
     
    2428 obj-$(CONFIG_MTD_NAND_AMS_DELTA)       += ams-delta.o 
    2529 obj-$(CONFIG_MTD_NAND_TOTO)            += toto.o 
    26 +obj-$(CONFIG_MTD_NAND_RB100)           += rbmipsnand.o 
     30+obj-$(CONFIG_MTD_NAND_ADM5120)         += adm5120-nand.o 
    2731 obj-$(CONFIG_MTD_NAND_AUTCPU12)                += autcpu12.o 
    2832 obj-$(CONFIG_MTD_NAND_EDB7312)         += edb7312.o 
  • trunk/target/linux/adm5120/router_le/config-2.6.22

    r8903 r8932  
    164164# CONFIG_MTD_NAND_NANDSIM is not set 
    165165# CONFIG_MTD_NAND_PLATFORM is not set 
    166 CONFIG_MTD_NAND_RB100=y 
     166CONFIG_MTD_NAND_ADM5120=y 
    167167# CONFIG_MTD_NAND_VERIFY_WRITE is not set 
    168168# CONFIG_MTD_ONENAND is not set 
Note: See TracChangeset for help on using the changeset viewer.