Changeset 45729


Ignore:
Timestamp:
2015-05-23T17:27:54+02:00 (3 years ago)
Author:
blogic
Message:

ipq806x: add power regulators support

Patches are cherry-picked from linux-next. We're also adding the
corresponding config option to the kernel.

Signed-off-by: Mathieu Olivari <mathieu@…>

Location:
trunk/target/linux/ipq806x
Files:
10 added
4 edited

Legend:

Unmodified
Added
Removed
  • trunk/target/linux/ipq806x/config-3.18

    r45663 r45729  
    8585CONFIG_CRC32_SLICEBY8=y 
    8686CONFIG_CROSS_MEMORY_ATTACH=y 
    87 # CONFIG_CRYPTO_DEV_QCE is not set 
    8887# CONFIG_CRYPTO_SHA1_ARM_NEON is not set 
    8988# CONFIG_CRYPTO_SHA512_ARM_NEON is not set 
     
    192191CONFIG_I2C_HELPER_AUTO=y 
    193192CONFIG_I2C_QUP=y 
     193# CONFIG_IEEE802154 is not set 
    194194CONFIG_IKCONFIG=y 
    195195CONFIG_IKCONFIG_PROC=y 
     
    212212CONFIG_MDIO_BOARDINFO=y 
    213213CONFIG_MDIO_GPIO=y 
     214CONFIG_MFD_QCOM_RPM=y 
    214215# CONFIG_MFD_SPMI_PMIC is not set 
     216CONFIG_MFD_SYSCON=y 
    215217CONFIG_MIGHT_HAVE_CACHE_L2X0=y 
    216218CONFIG_MIGHT_HAVE_PCI=y 
    217219CONFIG_MIGRATION=y 
    218 # CONFIG_MMC_SDHCI_MSM is not set 
    219220CONFIG_MODULES_USE_ELF_REL=y 
    220221CONFIG_MSM_GCC_8660=y 
     
    311312CONFIG_REGULATOR=y 
    312313# CONFIG_REGULATOR_DEBUG is not set 
     314CONFIG_REGULATOR_QCOM_RPM=y 
    313315# CONFIG_REGULATOR_USERSPACE_CONSUMER is not set 
    314316CONFIG_RESET_CONTROLLER=y 
  • trunk/target/linux/ipq806x/config-4.0

    r45663 r45729  
    5353CONFIG_ARM_VIRT_EXT=y 
    5454CONFIG_AT803X_PHY=y 
    55 # CONFIG_BATTERY_GAUGE_LTC2941 is not set 
    5655# CONFIG_BOOTPARAM_SOFTLOCKUP_PANIC is not set 
    5756CONFIG_BOOTPARAM_SOFTLOCKUP_PANIC_VALUE=0 
     
    222221CONFIG_MDIO_BOARDINFO=y 
    223222CONFIG_MDIO_GPIO=y 
    224 # CONFIG_MFD_QCOM_RPM is not set 
     223CONFIG_MFD_QCOM_RPM=y 
    225224# CONFIG_MFD_SPMI_PMIC is not set 
    226225CONFIG_MIGHT_HAVE_CACHE_L2X0=y 
     
    324323CONFIG_REGULATOR=y 
    325324# CONFIG_REGULATOR_DEBUG is not set 
     325CONFIG_REGULATOR_QCOM_RPM=y 
    326326# CONFIG_REGULATOR_USERSPACE_CONSUMER is not set 
    327327CONFIG_RESET_CONTROLLER=y 
     
    358358CONFIG_SWP_EMULATE=y 
    359359CONFIG_SYS_SUPPORTS_APM_EMULATION=y 
    360 # CONFIG_TEGRA_AHB is not set 
    361360CONFIG_THERMAL=y 
    362361# CONFIG_THERMAL_DEFAULT_GOV_FAIR_SHARE is not set 
  • trunk/target/linux/ipq806x/patches-3.18/700-add-gmac-dts-suport.patch

    r45728 r45729  
    120120--- a/arch/arm/boot/dts/qcom-ipq8064.dtsi 
    121121+++ b/arch/arm/boot/dts/qcom-ipq8064.dtsi 
    122 @@ -4,6 +4,7 @@ 
    123  #include <dt-bindings/clock/qcom,gcc-ipq806x.h> 
     122@@ -5,6 +5,7 @@ 
     123 #include <dt-bindings/mfd/qcom-rpm.h> 
    124124 #include <dt-bindings/soc/qcom,gsbi.h> 
    125125 #include <dt-bindings/reset/qcom,gcc-ipq806x.h> 
     
    128128 / { 
    129129        model = "Qualcomm IPQ8064"; 
    130 @@ -513,5 +514,42 @@ 
     130@@ -577,5 +578,42 @@ 
    131131                                dr_mode = "host"; 
    132132                        }; 
  • trunk/target/linux/ipq806x/patches-4.0/700-add-gmac-dts-suport.patch

    r45728 r45729  
    120120--- a/arch/arm/boot/dts/qcom-ipq8064.dtsi 
    121121+++ b/arch/arm/boot/dts/qcom-ipq8064.dtsi 
    122 @@ -4,6 +4,7 @@ 
    123  #include <dt-bindings/clock/qcom,gcc-ipq806x.h> 
     122@@ -5,6 +5,7 @@ 
     123 #include <dt-bindings/mfd/qcom-rpm.h> 
    124124 #include <dt-bindings/soc/qcom,gsbi.h> 
    125125 #include <dt-bindings/reset/qcom,gcc-ipq806x.h> 
     
    128128 / { 
    129129        model = "Qualcomm IPQ8064"; 
    130 @@ -415,5 +416,42 @@ 
     130@@ -479,5 +480,42 @@ 
    131131  
    132132                        status = "disabled"; 
Note: See TracChangeset for help on using the changeset viewer.