Changeset 42052


Ignore:
Timestamp:
2014-08-07T22:20:38+02:00 (3 years ago)
Author:
hauke
Message:

brcm47xx: 3.10: backport MIPS patches for early HIGHMEM support

Signed-off-by: Rafał Miłecki <zajec5@…>

Location:
trunk/target/linux/brcm47xx/patches-3.10
Files:
4 added
3 edited

Legend:

Unmodified
Added
Removed
  • trunk/target/linux/brcm47xx/patches-3.10/170-fix-74k-cpu.patch

    r39252 r42052  
    2323 #include <bcm47xx_nvram.h> 
    2424 #include <bcm47xx_board.h> 
    25 @@ -231,6 +232,31 @@ void __init plat_mem_setup(void) 
     25@@ -234,6 +235,31 @@ void __init plat_mem_setup(void) 
    2626        mips_set_machine_name(bcm47xx_board_get_name()); 
    2727 } 
  • trunk/target/linux/brcm47xx/patches-3.10/208-b44-use-fixed-PHY-device-if-we-do-not-find-any.patch

    r39469 r42052  
    3131 #include <linux/ssb/ssb_embedded.h> 
    3232 #include <linux/bcma/bcma_soc.h> 
    33 @@ -257,6 +260,12 @@ static int __init bcm47xx_cpu_fixes(void 
     33@@ -260,6 +263,12 @@ static int __init bcm47xx_cpu_fixes(void 
    3434 } 
    3535 arch_initcall(bcm47xx_cpu_fixes); 
     
    4444 { 
    4545        switch (bcm47xx_bus_type) { 
    46 @@ -275,6 +284,7 @@ static int __init bcm47xx_register_bus_c 
     46@@ -278,6 +287,7 @@ static int __init bcm47xx_register_bus_c 
    4747        bcm47xx_buttons_register(); 
    4848        bcm47xx_leds_register(); 
  • trunk/target/linux/brcm47xx/patches-3.10/830-huawei_e970_support.patch

    r39469 r42052  
    99 #include <asm/prom.h> 
    1010 #include <asm/reboot.h> 
    11 @@ -266,6 +267,33 @@ static struct fixed_phy_status bcm47xx_f 
     11@@ -269,6 +270,33 @@ static struct fixed_phy_status bcm47xx_f 
    1212        .duplex = DUPLEX_FULL, 
    1313 }; 
     
    4343 { 
    4444        switch (bcm47xx_bus_type) { 
    45 @@ -285,6 +313,7 @@ static int __init bcm47xx_register_bus_c 
     45@@ -288,6 +316,7 @@ static int __init bcm47xx_register_bus_c 
    4646        bcm47xx_leds_register(); 
    4747        bcm47xx_workarounds(); 
Note: See TracChangeset for help on using the changeset viewer.