Changeset 34111


Ignore:
Timestamp:
2012-11-07T21:26:21+01:00 (5 years ago)
Author:
blogic
Message:

ramips: use kernel 3.6.6

## Booting image at 80800000 ...

Image Name: MIPS OpenWrt Linux-3.6.6
Created: 2012-11-06 14:19:54 UTC

System Control Status = 0x20440000

Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 3560768 Bytes = 3.4 MB
Load Address: 80000000
Entry Point: 80000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

No initrd
## Transferring control to Linux (at address 80000000) ...
## Giving linux memsize in MB, 32

Starting kernel ...

[ 0.000000] Linux version 3.6.6 (daniel@…) (gcc version 4.6.4 20121001 (prerelease) (Linaro GCC 4.6-2012.10) ) #2 Tue Nov 6 16:19:48 IST 2012
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 0001964c (MIPS 24KEc)
[ 0.000000] Ralink RT3052 id:1 rev:2 running at 384.00 MHz
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 02000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x01ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x01ffffff]
[ 0.000000] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
[ 0.000000] Kernel command line: console=ttyS1,57600n8 board=ALL0239-3G mtdparts=physmap-flash.0:192k(u-boot)ro,64k(u-boot-env)ro,64k(factory)ro,896k(kernel),6976k(rootfs),7872k@0x50000(firmware) rootfstype=squashfs,jffs2
[ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] ex_table already sorted, skipping sort
[ 0.000000] Writing ErrCtl register=0000c388
[ 0.000000] Readback ErrCtl register=0000c388
[ 0.000000] Memory: 27048k/32768k available (2015k kernel code, 5720k reserved, 498k data, 2676k init, 0k highmem)
[ 0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:48
[ 0.000000] console [ttyS1] enabled, bootconsole disabled
[ 0.000000] console [ttyS1] enabled, bootconsole disabled
[ 0.010000] Calibrating delay loop... 255.59 BogoMIPS (lpj=1277952)
[ 0.090000] pid_max: default: 32768 minimum: 301
[ 0.100000] Mount-cache hash table entries: 512
[ 0.110000] NET: Registered protocol family 16
[ 0.120000] MIPS: machine is Allnet ALL0239-3G
[ 0.140000] bio: create slab <bio-0> at 0
[ 0.150000] Switching to clocksource MIPS
[ 0.160000] NET: Registered protocol family 2
[ 0.170000] TCP established hash table entries: 1024 (order: 1, 8192 bytes)
[ 0.180000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.200000] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.210000] TCP: reno registered
[ 0.220000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.230000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.240000] NET: Registered protocol family 1
[ 5.460000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 5.470000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 5.490000] msgmni has been set to 52
[ 5.500000] io scheduler noop registered
[ 5.510000] io scheduler deadline registered (default)
[ 5.520000] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
[ 5.530000] serial8250: ttyS0 at MMIO 0x10000500 (irq = 13) is a 16550A
[ 5.550000] serial8250: ttyS1 at MMIO 0x10000c00 (irq = 20) is a 16550A
[ 5.560000] physmap platform flash device: 00800000 at bf000000
[ 5.580000] physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x000001 Chip ID 0x001000
[ 5.600000] Amd/Fujitsu Extended Query Table at 0x0040
[ 5.610000] Amd/Fujitsu Extended Query version 1.3.
[ 5.620000] number of CFI chips: 1
[ 5.620000] 6 cmdlinepart partitions found on MTD device physmap-flash.0
[ 5.640000] Creating 6 MTD partitions on "physmap-flash.0":
[ 5.650000] 0x000000000000-0x000000030000 : "u-boot"
[ 5.660000] 0x000000030000-0x000000040000 : "u-boot-env"
[ 5.680000] 0x000000040000-0x000000050000 : "factory"
[ 5.690000] 0x000000050000-0x000000130000 : "kernel"
[ 5.700000] 0x000000130000-0x000000800000 : "rootfs"
[ 5.710000] mtd: partition "rootfs" set to be root filesystem
[ 5.730000] split_squashfs: error occured while reading from "physmap-flash.0"
[ 5.740000] 0x000000050000-0x000000800000 : "firmware"
[ 5.760000] ramips-wdt ramips-wdt: timeout value must be 0 < timeout <= 33, using 33
[ 5.780000] TCP: cubic registered
[ 5.780000] NET: Registered protocol family 17
[ 5.790000] 8021q: 802.1Q VLAN Support v1.8
[ 5.820000] Freeing unused kernel memory: 2676k freed
[ 6.490000] Button Hotplug driver version 0.4.1

  • preinit -

Press the [f] key and hit [enter] to enter failsafe mode

  • regular preinit -
  • init -

Please press Enter to activate this console. [ 10.150000] Compat-drivers backport release: compat-drivers-2012-09-04-2-gddac993
[ 10.170000] Backport based on wireless-testing.git master-2012-09-07
[ 10.180000] compat.git: wireless-testing.git
[ 10.210000] cfg80211: Calling CRDA to update world regulatory domain
[ 10.230000] cfg80211: World regulatory domain updated:
[ 10.240000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 10.250000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 10.270000] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 10.280000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 10.300000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 10.310000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 10.430000] NET: Registered protocol family 10
[ 10.760000] PPP generic driver version 2.4.2
[ 10.820000] l2tp_core: L2TP core driver, V2.0
[ 10.840000] l2tp_netlink: L2TP netlink interface
[ 10.870000] sit: IPv6 over IPv4 tunneling driver
[ 10.920000] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 11.060000] NET: Registered protocol family 24
[ 11.090000] nf_conntrack version 0.5.0 (464 buckets, 1856 max)
[ 11.230000] l2tp_ppp: PPPoL2TP kernel driver, V2.0
[ 11.410000] ip6_tables: (C) 2000-2006 Netfilter Core Team
[ 14.510000] device eth0.1 entered promiscuous mode
[ 14.520000] device eth0 entered promiscuous mode
[ 14.530000] IPv6: ADDRCONF(NETDEV_CHANGE): eth0.1: link becomes ready
[ 14.550000] br-lan: port 1(eth0.1) entered forwarding state
[ 14.560000] br-lan: port 1(eth0.1) entered forwarding state
[ 16.560000] br-lan: port 1(eth0.1) entered forwarding state
[ 16.600000] ramips-wdt: timeout value 60 must be 0 < timeout <= 33, using 33

BusyBox v1.19.4 (2012-11-06 13:40:37 IST) built-in shell (ash)
Enter 'help' for a list of built-in commands.

_

| |.-----.-----.-----.| | | |.----.| |_

| - |_
_ | -| | | _ _|
|_||| ||

|| W I R E L E S S F R E E D O M

-----------------------------------------------------
BARRIER BREAKER (Bleeding Edge, r34079)
-----------------------------------------------------

  • 1/2 oz Galliano Pour all ingredients into
  • 4 oz cold Coffee an irish coffee mug filled
  • 1 1/2 oz Dark Rum with crushed ice. Stir.
  • 2 tsp. Creme de Cacao

-----------------------------------------------------

root@OpenWrt:/#

File:
1 edited

Legend:

Unmodified
Added
Removed
Note: See TracChangeset for help on using the changeset viewer.