Ticket #5018: dmesg.txt

File dmesg.txt, 7.0 KB (added by danielw86@…, 9 years ago)
Line 
1Linux version 2.6.28.9 (wieszti@hp) (gcc version 4.1.2) #6 Mon Apr 27 22:27:31 CEST 2009
2CPU revision is: 00029008 (Broadcom BCM3302)
3ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x0E, vendor 0x4243)
4ssb: Core 1 found: Fast Ethernet (cc 0x806, rev 0x09, vendor 0x4243)
5ssb: Core 2 found: MIPS 3302 (cc 0x816, rev 0x06, vendor 0x4243)
6ssb: Core 3 found: USB 1.1 Host (cc 0x817, rev 0x02, vendor 0x4243)
7ssb: Core 4 found: MEMC SDRAM (cc 0x80F, rev 0x01, vendor 0x4243)
8ssb: Core 5 found: IEEE 802.11 (cc 0x812, rev 0x09, vendor 0x4243)
9ssb: Core 6 found: Roboswitch (cc 0x81C, rev 0x02, vendor 0x4243)
10ssb: Initializing MIPS core...
11ssb: set_irq: core 0x0806, irq 2 => 2
12ssb: set_irq: core 0x0817, irq 4 => 3
13ssb: set_irq: core 0x0812, irq 0 => 4
14ssb: Sonics Silicon Backplane found at address 0x18000000
15Serial init done.
16Determined physical RAM map:
17 memory: 01000000 @ 00000000 (usable)
18Initrd not found or empty - disabling initrd
19Zone PFN ranges:
20  Normal   0x00000000 -> 0x00001000
21Movable zone start PFN for each node
22early_node_map[1] active PFN ranges
23    0: 0x00000000 -> 0x00001000
24On node 0 totalpages: 4096
25free_area_init_node: node 0, pgdat 80250f40, node_mem_map 80297000
26  Normal zone: 32 pages used for memmap
27  Normal zone: 0 pages reserved
28  Normal zone: 4064 pages, LIFO batch:0
29  Movable zone: 0 pages used for memmap
30Built 1 zonelists in Zone order, mobility grouping off.  Total pages: 4064
31Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200
32Primary instruction cache 16kB, VIPT, 2-way, linesize 16 bytes.
33Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes
34PID hash table entries: 64 (order: 6, 256 bytes)
35console [ttyS0] enabled
36Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
37Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
38Memory: 13588k/16384k available (2054k kernel code, 2796k reserved, 318k data, 128k init, 0k highmem)
39Calibrating delay loop... 199.16 BogoMIPS (lpj=398336)
40Mount-cache hash table entries: 512
41net_namespace: 480 bytes
42NET: Registered protocol family 16
43Switched to high resolution mode on CPU 0
44NET: Registered protocol family 2
45IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
46TCP established hash table entries: 512 (order: 0, 4096 bytes)
47TCP bind hash table entries: 512 (order: -1, 2048 bytes)
48TCP: Hash tables configured (established 512 bind 512)
49TCP reno registered
50NET: Registered protocol family 1
51detected lzma initramfs
52initramfs: LZMA lc=1,lp=2,pb=2,origSize=512
53squashfs: version 3.0 (2006/03/15) Phillip Lougher
54Registering mini_fo version $Id$
55JFFS2 version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
56msgmni has been set to 26
57io scheduler noop registered
58io scheduler deadline registered (default)
59Serial: 8250/16550 driver2 ports, IRQ sharing enabled
60serial8250: ttyS0 at MMIO 0xb8000300 (irq = 3) is a 16550A
61serial8250: ttyS1 at MMIO 0xb8000400 (irq = 3) is a 16550A
62serial8250.0: ttyS0 at MMIO 0xb8000300 (irq = 3) is a 16550A
63serial8250.0: ttyS1 at MMIO 0xb8000400 (irq = 3) is a 16550A
64b44.c:v2.0
65eth0: Broadcom 44xx/47xx 10/100BaseT Ethernet 00:16:01:af:bc:a8
66flash init: 0x1c000000 0x02000000
67Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
68Physically mapped flash: Found an alias at 0x400000 for the chip at 0x0
69Physically mapped flash: Found an alias at 0x800000 for the chip at 0x0
70Physically mapped flash: Found an alias at 0xc00000 for the chip at 0x0
71Physically mapped flash: Found an alias at 0x1000000 for the chip at 0x0
72Physically mapped flash: Found an alias at 0x1400000 for the chip at 0x0
73Physically mapped flash: Found an alias at 0x1800000 for the chip at 0x0
74Physically mapped flash: Found an alias at 0x1c00000 for the chip at 0x0
75 Amd/Fujitsu Extended Query Table at 0x0040
76number of CFI chips: 1
77cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
78Flash device: 0x400000 at 0x1fc00000
79bootloader size: 262144
80Creating 4 MTD partitions on "Physically mapped flash":
810x00000000-0x00040000 : "cfe"
820x00040000-0x003f0000 : "linux"
830x000ffc00-0x003f0000 : "rootfs"
84mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
85mtd: partition "rootfs" set to be root filesystem
86mtd: partition "rootfs_data" created automatically, ofs=2B0000, len=140000
870x002b0000-0x003f0000 : "rootfs_data"
880x003f0000-0x00400000 : "nvram"
89TCP vegas registered
90NET: Registered protocol family 17
91802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
92All bugs added by David S. Miller <davem@redhat.com>
93VFS: Mounted root (squashfs filesystem) readonly.
94Freeing unused kernel memory: 128k freed
95Please be patient, while OpenWrt loads ...
96Algorithmics/MIPS FPU Emulator v1.5
97diag: Detected 'Buffalo WHR-G54S'
98b44: eth0: Link is up at 100 Mbps, full duplex.
99b44: eth0: Flow control is off for TX and off for RX.
100roboswitch: Probing device eth0: found!
101b44: eth0: powering down PHY
102mini_fo: using base directory: /
103mini_fo: using storage directory: /jffs
104b44: eth0: Link is up at 100 Mbps, full duplex.
105b44: eth0: Flow control is off for TX and off for RX.
106device eth0.0 entered promiscuous mode
107device eth0 entered promiscuous mode
108br-lan: topology change detected, propagating
109br-lan: port 1(eth0.0) entering forwarding state
110PPP generic driver version 2.4.2
111cfg80211: Using static regulatory domain info
112cfg80211: Regulatory domain: US
113        (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
114        (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
115        (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
116        (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
117        (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
118        (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
119        (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
120cfg80211: Calling CRDA for country: US
121NET: Registered protocol family 24
122b43-phy0: Broadcom 5352 WLAN found (core revision 9)
123phy0: Selected rate control algorithm 'minstrel'
124Broadcom 43xx driver loaded [ Features: PLR, Firmware-ID: FW13 ]
125ip_tables: (C) 2000-2006 Netfilter Core Team
126br-lan: port 1(eth0.0) entering disabled state
127br-lan: topology change detected, propagating
128br-lan: port 1(eth0.0) entering forwarding state
129nf_conntrack version 0.5.0 (256 buckets, 1024 max)
130input: b43-phy0 as /devices/virtual/input/input0
131b43 ssb0:3: firmware: requesting b43/ucode5.fw
132b43 ssb0:3: firmware: requesting b43/pcm5.fw
133b43 ssb0:3: firmware: requesting b43/b0g0initvals5.fw
134b43 ssb0:3: firmware: requesting b43/b0g0bsinitvals5.fw
135b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
136Registered led device: b43-phy0::tx
137Registered led device: b43-phy0::rx
138b43-phy0: Radio turned on by software
139device wlan0 entered promiscuous mode
140wlan0: deauthenticating by local choice (reason=3)
141br-lan: port 2(wlan0) entering disabled state
142input: b43-phy0 as /devices/virtual/input/input1
143b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
144Registered led device: b43-phy0::tx
145Registered led device: b43-phy0::rx
146br-lan: topology change detected, propagating
147br-lan: port 2(wlan0) entering forwarding state